I built this bumper as a prototype and it has a couple issues that aren't too hard to fix, but I am knee deep in other projects so I want to sell this and build a revised design.
It's 3/16" steel plate with a 3/8" thick winch/mounting plate. Fits most any winch without relocating the solenoid box. Fully welded and gusseted for strength. Toyota is cutout on the front. 1" thick shackle mounts tied into the winch plate. Fog light holes. Herculined and painted black. Mounts with 6 bolts to factory frame mounts. Would fit 98-00 Tacomas with modification to the frame horns. Factory skid plate hole position.
The bad: it sits tilted back when viewed from the side, so there is a small gap between the bumper and grille/headlights that gets wider by the fender. The mounting holes were redrilled to try and combat this, but didn't help much. Also, the side plate is vertical instead of angled to the fender opening. Would be an easy DIY fab project to get it tight and right. I'll even send a small sheet of 3/16" with for the repairs.
12,500 lb Tuff Stuff waterproof winch not included or extra $375.
Shipping will be via either UPS or Fedex (whichever is cheapest), or pick up in Ames, Iowa.
I know this is probably a long shot, but whatever. Someone wants a little fall project out there.