1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

FS: Wookie-strength carrier bearing

Discussion in '1st Gen Tacoma Parts Marketplace (1995-2004)' started by davidpick, Jan 16, 2014.

  1. Jan 16, 2014 at 6:08 PM
    #1
    davidpick

    davidpick [OP] NWXPDTN

    Joined:
    Jan 21, 2010
    Member:
    #29760
    Messages:
    2,380
    Gender:
    Male
    First Name:
    David
    Leavenworth, WA
    Vehicle:
    1988 Pickup 22R 5sp 2wd
    Weber 32/36, RV Cam, LCE exhaust headers, Desmogged
    SOLD!

    This is the bearing used for the " ". It's a McMaster-Carr pillow block bearing, this one with less than 5 miles on it (I bought it new and did a quick test drive). I installed this over the holidays in the hopes that I could avoid buying another carrier bearing, but in my opinion for a daily-driver, this mod isn't viable. Just too much noise above ~55mph. For a dedicated trail rig, I would have NO hesitation installing this bearing.

    This is the exact part you're getting: http://www.mcmaster.com/#2722t25/=qa6y2g

    I realize there is a pretty small market for this, but you could save some serious coin here!

    This was $120 shipped when new from Mcmaster Carr. Asking $60 shipped to the CONUS.
     
    Last edited: Jan 17, 2014
  2. Jan 17, 2014 at 4:21 PM
    #2
    davidpick

    davidpick [OP] NWXPDTN

    Joined:
    Jan 21, 2010
    Member:
    #29760
    Messages:
    2,380
    Gender:
    Male
    First Name:
    David
    Leavenworth, WA
    Vehicle:
    1988 Pickup 22R 5sp 2wd
    Weber 32/36, RV Cam, LCE exhaust headers, Desmogged

Products Discussed in

To Top