Looking For DIY, Have already searched forums...

I have a 98 Tacoma with the v6 5vz motor, I need to replace the valve cover gasket and i don't wanna mess anything up taking the intake manifold off. If anyone knows of a DIY out there for this, it would be very greatly appreciated.

THANKS!

 

Disconnect these cables
(1) w/ Cruise control:
Cruise control actuator cable
(2) Accelerator cable
(3) A/T:
Throttle cable
8. DISCONNECT HOSES
Disconnect these hoses:
(1) Brake booster vacuum hose
(2) EVAP hose
(3) 4WD only:
A.D.D. Vacuum hose
(4) Fuel return hose
(5) Fuel inlet hose
9. REMOVE INTAKE CHAMBER STAY
(a) Remove the 2 bolts and No.1 throttle cable clamp.
(b) Remove the 2 bolts and intake chamber stay.
10. REMOVE NO.2 TIMING BELT COVER
S02070
S02071
S02072
S02073
EM−30
ENGINE MECHANICAL (5VZ−FE) − CYLINDER HEAD
Author: Date: 945
11. REMOVE AIR INTAKE CHAMBER ASSEMBLY
(a) Disconnect these connectors and these hoses:
(1) Throttle position sensor connector
(2) IAC valve connector
(3) 2 PCV hoses
(4) 2 water bypass hoses
(5) Air assist hose from throttle body
(b) Remove the 4 bolts, 2 nuts, the air intake chamber assembly
and gasket.
12. REMOVE INTAKE AIR CONNECTOR
(a) Remove the bolt and disconnect the engine wire.
(b) Disconnect these hoses:
(1) Fuel return hose
(2) Vacuum hose from the fuel pressure regulator
(c) Remove the bolt and disconnect the ground strap from
the intake air connector.
(d) Disconnect the DLC1 from the bracket.
(e) Remove the 3 bolts and 2 nuts, then intake air connector
and gasket.