What have you done to your Tacoma today? 1st Gen Edition

Just put these on today, swapped them out for the grabbers I had before
33/12.50/15

 

My buddy in brown finally dropped off my new headlights!!!





Throwin em on tomorrow!!! My trucks going to look ten years newer...

 

changed my oil

 

make sure to wax them to help protect from UV rays

 

Anyone here have an opinion on Hawk HPS vs. LTS pads? They are both about the same price. I'm leaning toward LTS. Or is there something better I should get? I'm going to do stainless braided lines at the same time I think.

 

I hope u we're talking to me,

What kind of wax are you talking??

 

Got n an accident

 

pics

 

Don't have any pics the lady was going crazy and the cops told me to leave

 

How did it happen ^^?

 

I was turning at an intersection and she was going straight and Ididn't see her because she didn't have her lights on

 

got my new cvs from cvj, anyone know if oem differs this much?







When sitting the new ones are about an inch shorter then my originals. They can pull out or push in, is this normal?

Basically I'm wondering if they sent OEM and if they are correct for tacomas.

 

yes you any kind of wax the UVs break down the clear on the headlights wax helps protect them. just use whatever you have lying around you use on the truck

 

Who got the fault? Sux, hows the truck?

 

I went with the LTS when I did Pads and rotors last fall. No complaints here. Not much different than whatever was on there before, except no more warped rotors.

 

So it was at night?
I see many idiots lately at night driving with no lights on there so stupid

 

Those don't look at all like OEM. Even the crappy aftermarket CVs I've seen look more like OEM. Could they be for the pre-taco?

Here's one of my OEM (minus the dust seal) next to a GSP brand axle.



The push/pull you mentioned is normal, it's just dislocated when pulled like that. Obviously not supposed to work that way though haha

 

Those are not pre taco cv's the hub side had a more sa type end since that gen ifs had similar spindles/hubs to the sa. Whatever they are they look weak, never seen that kind of a neck down in the middle of a cv like that.

 

CVJ's should be OEM. Give them a call.