What have you done to your Tacoma today? 1st Gen Edition

Do NOT run the shim type spacers without extending your lugs. The stock front lugs are stupid short as it is.

 

So granted i get extended lugs is there any other reason to not use them?

 

Take it from me ('99) that's not going to fix your full flex rub, you're just going to get into the fender. get longer bump stops, trim, and if you have the same issue as me, axle relocation blocks for the rear. $.02

 

I changed out my 2002 fuel door with a 2000 fuel door with locking cylinder.

 

sweet. i didnt know about this mod. howd u get it keyed and is that carbon fiber?

 

The 98-00 typically have locking ones so you just swap it

 

I rekeyed mine all i did was take apart the lock and kept rearranging the pins untill my key worked the lock
Took maybe an hour
Also i snagged the lock out of another fuel door so i had extra pins to make sure i had enough for my lock to be keyed to my key

 

I heard the same when i had that problem. I went and got 1'' Spacers from BORA. have had them for two years, put over 6 thousand miles on them, took them offroading and wheeling, no problems...

 

Replaced lower ball joints and inner and outer tie rods. Passenger side wasn't too bad but both driver side ball joint and outer tie rod boots were ripped. Overall it went a lot smoother than expected.

 

Clay barred and done the paint correction process from chemical guys but used meguiars products, think it turned out pretty good

 

Thanks, no it's 3M vinyl

 

Had a guy i know telling me all about how he installed one of these on his t4r and how he loved it so much and what not

Anyone have any experience with these, also the guy had an N/A 3.4
http://urdusa.com/store/Electronics...1/URD-MAF-Sensor-Calibrator/product_info.html

Just wondering if it is really worth it for a N/A truck that plans on staying that way

 

Front end overhaul, and some off roading today. Check out the build page or album for the rest

 

Giving the bumper a new shade tonight. Gloss black instead of the grey I got it as. And covering up the bare metal from the new light tabs.

 

Nope. Not worth it.

 

plasitdipped the door badges and the peeling window trim

 

Almost got my rigids fully wired. Only thing is that the harness is like an inch too short and the connectors they use on it dont fit on daystar switches, which I find a little odd. So going to extend the wire and add bigger female pieces.

 

Ugh I hate that damn window trim!! I have yet to rip all the rest off down to the chrome. On my todo list. How did it come out?

 

Nice! that's what I'm talking about

 

Havent posted in a while but I got my relentless DIY done. Still have to rhino line it and wire up my rigid d2's then I will post up pics with the finished product!