Mike "Wuzzy121". Rest in peace, brother

Go Back   Tacoma World Forums > Tacoma Discussion > 1st Gen. Tacomas

Notices

line-x and tonneau cover question...

Reply
 
Thread Tools Search this Thread
Old 02-14-2011, 06:12 AM   #1
tacod [OP] tacod is offline
Member
tacod is on a distinguished road
Name: Dan
Joined: Aug 2010, #41322
Location: Kemblesville, PA
Gender: Male
Posts: 50
tacod's Tacoma Gallery
line-x and tonneau cover question...

planning to get rid of my plastic bedliner and replace with line-x over the rails. question: will there be any trouble putting rails for a tonneau cover on top of the line-x coating on the tops of the bed rails?

thanks in advance!
  Reply With Quote
Old 02-14-2011, 06:45 AM   #2
Old & Forgetful
Janster is one of the sharper tools in the shedJanster is one of the sharper tools in the shedJanster is one of the sharper tools in the shedJanster is one of the sharper tools in the shedJanster is one of the sharper tools in the shedJanster is one of the sharper tools in the shedJanster is one of the sharper tools in the shedJanster is one of the sharper tools in the shedJanster is one of the sharper tools in the shedJanster is one of the sharper tools in the shedJanster is one of the sharper tools in the shed
 
Janster's Avatar
Name: Jandy
Joined: Mar 2007, #1138
Location: Lancaster, PA
Age: 46
Gender: Female
Posts: 12,982
Janster's Tacoma Gallery
I used Herculiner - so its not nearly as thick as a professionally sprayed LineX.

It'll depend on the clamping system that the tonneau cover uses. What kind of tonneau cover are you getting?

I had a tonneau cover on my 96 with the Herculiner..... it used C type clamps.

I would say you'll be fine and I'm sure its been done before. But, it won't hurt to list what tonneau cover your getting and see if you get any other responses.
  Reply With Quote
Old 02-14-2011, 06:54 AM   #3
tacod [OP] tacod is offline
Member
tacod is on a distinguished road
Name: Dan
Joined: Aug 2010, #41322
Location: Kemblesville, PA
Gender: Male
Posts: 50
tacod's Tacoma Gallery
thanks for the reply...i'm planning to use an extang tuff tonno cover, which uses clamps similar to those you've shown. image from extang installation instructions.
Attached Thumbnails
line-x and tonneau cover question...-clamp-image.gif  
  Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
Tonneau Cover Question wurthit4660 1st Gen. Tacomas 6 10-04-2011 06:43 PM
Tonneau cover question emanb115 2nd Gen. Builds 0 06-03-2010 01:32 PM
Tonneau cover installation question prsgeetarman 2nd Gen. Tacomas 12 11-21-2009 05:36 PM
Tonneau cover question rd263 2nd Gen. Tacomas 8 10-26-2009 01:03 PM
Tonneau Cover Question msu12181 2nd Gen. Tacomas 36 05-29-2009 07:03 AM


Copyright © 2014 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.