Delta00's 2002 Tacoma 4WD

Go Back   Tacoma World Forums > Tacoma Discussion > 1st Gen. Tacomas


Seat Belt Bolt Size - 60/40

Thread Tools Search this Thread
Old 11-12-2011, 05:27 PM   #1
Singlecab [OP] Singlecab is offline
Junior Member
Singlecab is on a distinguished road
Joined: Nov 2011, #66921
Location: Wy
Gender: Male
Posts: 6
Singlecab's Tacoma Gallery
Seat Belt Bolt Size - 60/40

Hi folks, just joined the forum. I'm right in the middle of a seat swap - swapping buckets to the 60/40 bench seats. (96 Tacoma regular cab, using seats from a 98 extended cab).

Anyone know the size of bolt that holds the seat belt receiver / buckle mount on the driver's seat? The bolt hole looks about 12mm, but would like to know the exact size / thread pitch so I don't have to buy a bunch and see what fits.

I'll be looking for the original style 60/40 seat belt for driver / passenger, but will also try to see if I can use my original bucket style receiver.
  Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
WTB: 60/40 Driver's Seat Belt Receiver - can trade bucket seatbelt receiver Singlecab 1st Gen Tacoma Marketplace 3 12-18-2011 03:52 PM
60/40 swap t 40/40 seat. chazjb 1st Gen. Tacomas 4 05-13-2011 08:23 AM
Bench Seat To 60/40? chadd925 1st Gen. Tacomas 1 10-24-2010 07:57 AM
Want to change out my bench seat for a 60/40 h_curtis 1st Gen. Tacomas 6 04-09-2010 07:40 AM
First gen. 60/40 front seat FREE oldtacomaguy Buy / Sell / Trade 1 02-22-2009 07:03 AM

Copyright © 2015 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.