1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

how long should i wait?

Discussion in '1st Gen. Tacomas (1995-2004)' started by grogs34, Jan 19, 2012.

  1. Jan 19, 2012 at 6:44 PM
    #1
    grogs34

    grogs34 [OP] Senior Member

    Joined:
    Dec 30, 2011
    Member:
    #69668
    Messages:
    27
    Gender:
    Male
    First Name:
    Jake
    Vehicle:
    1998 tacoma
    lifted 2 inches,32x11.5x15
    I just installed the deck plate mod and i used the sensor safe silicon. I have heard that it is ok to install right away and I have heard to wait 24 hours to let it dry because if you don't, it will make your check engine light come on. What do i do?
     
  2. Jan 19, 2012 at 6:52 PM
    #2
    Project.paradigm

    Project.paradigm Well-Known Member

    Joined:
    Dec 27, 2009
    Member:
    #28258
    Messages:
    444
    Gender:
    Male
    Oil Country,Alberta, Canada
    Vehicle:
    04 TRD 4X4 Dub cab
    Airlift rear air bags. Hood struts. sockmonkey bedside decal. TRD supercharger(not installed). Deckplate. Grey wire mod. Extended rear diff breather. 6000k HIDS. 18"Magnaflow. Truxxx 3" level kit. (Temporary) Wet Okole seat covers. BoxRocket bed rack. Bora 0.75 wheel spacers All pro sliders. BAMF BPV. B&M trans cooler.
    Safest thing to do is wait 24hrs. If you need to drive i wouldn't be too worried about it. I didn't and i was okay. Used silicon that dried quickly though.
     

Products Discussed in

To Top