Delta00's 2002 Tacoma 4WD

Go Back   Tacoma World Forums > Tacoma Discussion > 1st Gen. Tacomas


`95 Tacoma, Installed `91 rear end. sensor help.

Thread Tools Search this Thread
Old 04-30-2013, 09:18 AM   #1
Caledonia [OP] Caledonia is offline
Junior Member
Caledonia is on a distinguished road
Joined: Apr 2013, #103177
Location: NB, Canada
Gender: Male
Posts: 1
Caledonia's Tacoma Gallery
`95 Tacoma, Installed `91 rear end. sensor help.


I swapped out my Bad Rear end out of my `95 2.7L Tacoma with one from `91 2.4L 4x4 Tacoma.

on my `95 tacoma there are two rear sensors mounted near the rear hubs

on the `91 there is only one sensor in the middle of the dif on top of the pumpkin.

Can I just wire in the single harness from the '91 by splicing it into the electrical from the 2 sensors on the `95?

assuming the 2 sensors on the axles of the '95 differential are the same kind of sensor on the '91 differential...
  Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
Installed Ultra Gauge on '95 Tacoma dark tangent 1st Gen. Tacomas 28 12-17-2014 02:48 PM
How common is the 3.91 rear? Clark 1st Gen. Tacomas 10 09-19-2012 06:10 AM
95 throttle position sensor yote69301 1st Gen Tacoma Marketplace 2 02-29-2012 12:07 AM
Help needed for a live reading of rear o2 sensor (bank 1 sensor 2) geoff06 Technical Chat 7 11-30-2011 05:57 AM
3.4 coil packs, rear O2 sensor, water temp sensor glassdoc Buy / Sell / Trade 6 01-28-2009 07:51 AM

Copyright © 2015 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.