1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

285 Clearancing

Discussion in '1st Gen. Tacomas (1995-2004)' started by JCH, May 4, 2013.

  1. May 12, 2013 at 12:50 PM
    #21
    paranoid56

    paranoid56 Well-Known Member

    Joined:
    Jul 25, 2012
    Member:
    #83443
    Messages:
    3,387
    Gender:
    Male
    San Diego
    Vehicle:
    14 double cab taco
    i pulled my fender liner out, pounded the seam flat then reinstalled the liner and heated it up and reformed it to to the new contour. no rubbing and looks factory.
     
  2. May 12, 2013 at 3:56 PM
    #22
    Lumpskie

    Lumpskie Independent Thinker

    Joined:
    Apr 20, 2013
    Member:
    #102450
    Messages:
    1,978
    Gender:
    Male
    New Hampshire
    Vehicle:
    '96, 4x4, v6, manual hub
    Toytec 16" coilovers with Tundra Bilstein 5100s, Light Racing UCAs, Alcan Leafs with Orbit Eyes, 12" Bilstein 7100 short Bodies, ARB rear locker, 33x12.5 Duratracs, CBI sliders, Bushwacker fender flares, self made front bumper, M8000, Vision X 6.7" Hi/Lo Beam HIDs, full skids, Inchworm dual case setup - 15º clocking
    ^I was thinking about doing exactly that. Do you have any pictures? What did you use to heat the plastic?
     
  3. May 13, 2013 at 7:41 AM
    #23
    paranoid56

    paranoid56 Well-Known Member

    Joined:
    Jul 25, 2012
    Member:
    #83443
    Messages:
    3,387
    Gender:
    Male
    San Diego
    Vehicle:
    14 double cab taco
    i will try to take a pic, but i just used a torch and just warmed it up till i could mold it. a heat gun should also work.
     

Products Discussed in

To Top