Hey guys. I'm new here so please bear with me if I don't something correctly on this forum.
I changed my engine last week after deciding the original was to far gone. Engin knocking, crank, rod were bad so I bought a used engine. To install I had to remove the intake and disconnect almost all hoses. I'm at a lost now. I didn't number or tag them so yea I know I screwed up. Now the engine won't start unless I squirt gas into the intake. It ran before I changed the engine just fine until I replaced the engine.
So. My first question.
1. Does anyone have a really good diagram of the vacuum hoses.
2. Any ideas on which hose or wire I have hooked up wrong to not allow fuel to be delivered to the engine.
Thanks guys any help will be greatly appreciated.