Mike "Wuzzy121". Rest in peace, brother

Go Back   Tacoma World Forums > Tacoma Discussion > 1st Gen. Tacomas

Notices

Embedded bolt thread replacement?

Reply
 
Thread Tools Search this Thread
Old 08-25-2013, 05:36 PM   #1
iBokhari [OP] iBokhari is offline
Junior Member
iBokhari is on a distinguished road
Name: Imraan
Joined: Aug 2013, #110588
Location: Tucson, Arizona
Gender: Male
Posts: 9
iBokhari's Tacoma Gallery
Embedded bolt thread replacement?

painted my mirrors

First hic-up happened when I was removing the screw that connected the two pieces of the mirror together allowing it to be adjusted.

The 1/4" bolt broke at the last half inch or so, tried to remove again with an extractor and ended up popping out the piece that the bolt threads into, couldn't remove w/ vice grips.. super stuck...

QUESTION:

Is an epoxy even strong enough to hold tension from the spring? I would attempt using a long nut if the glue would hold, doubt the broken bolts coming out
  Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
Bolt on Wheel Bearing replacement? ffemt2987 2nd Gen. Tacomas 41 01-26-2012 11:18 PM
Front lower strut bolt replacement? TRDSPORTtaco 2nd Gen. Tacomas 2 04-20-2011 07:19 PM
What is embedded XM radio? bizjettech 2nd Gen. Tacomas 4 04-03-2011 11:47 AM
Break Caliper Bolt Replacement Ben Warren 1st Gen. Tacomas 2 06-04-2009 04:56 PM


Copyright © 2014 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.