Alignment Problems?

Mootsman · Nov 14, 2009

Just wondering - This 02 Tacoma is my first lifted vehicle. I bought it used. It has a Fabtech kit, and is lifted about 3". I noticed a little uneven wear on the front end, so I'm about to get it aligned, although it seems to go very straight down the road - no big problems. I was just wondering if you have more alignment problems in general with a lift kit installed.

Thanks

chris4x4 · Nov 14, 2009

When lifting, the geometry goes out. It can be brought back pretty close to OEM specs, but it will be near the max recomended adjustments. Many people get aftermarket UCA's (Upper Control Arms) that correct for these issues. Idealy, you want your Camber and Toe set as close to 0* as possible, if not right at 0*. You want the Caster between 2.2* to 2.9* or so.

Mootsman · Nov 14, 2009

Thanks, i think I will get it aligned next week and see how close they can get it.

Log in or Sign up

Welcome to Tacoma World!

Alignment Problems?

#1
Mootsman [OP] Active Member

#2
chris4x4 With sufficient thrust, pigs fly just fine. Moderator

#3
Mootsman [OP] Active Member

Products Discussed in

Log in or Sign up

Useful Searches

Welcome to Tacoma World!

Alignment Problems?

#1 Mootsman [OP] Active Member

#2 chris4x4 With sufficient thrust, pigs fly just fine. Moderator

#3 Mootsman [OP] Active Member

Products Discussed in Entire Site Forum: 1st Gen. Tacomas (1995-2004)

#1
Mootsman [OP] Active Member

#2
chris4x4 With sufficient thrust, pigs fly just fine. Moderator

#3
Mootsman [OP] Active Member

Products Discussed in