1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

how to lube the release fork?

Discussion in '1st Gen. Tacomas (1995-2004)' started by NC Tacoma, Oct 10, 2010.

  1. Oct 10, 2010 at 6:50 AM
    #1
    NC Tacoma

    NC Tacoma [OP] Well-Known Member

    Joined:
    Dec 10, 2008
    Member:
    #11454
    Messages:
    55
    Gender:
    Male
    First Name:
    Marty
    Wadesboro NC
    Vehicle:
    4X4 TRD Sport
    Could someone tell me how this is done?
     
  2. Oct 10, 2010 at 6:57 AM
    #2
    afd23a

    afd23a Well-Known Member

    Joined:
    Sep 26, 2008
    Member:
    #9483
    Messages:
    1,832
    Gender:
    Male
    The Dynamo of Dixie
    Vehicle:
    05 Access Cab 5 Lugger
    Factory Fog Lights, Removed Secondary Air Filter, Metra Ipod Adapter, Int Wiper Stalk, Wet Okole's, URD Short Shifter, Scanguage II w/Blendmount, Fat Bob's 2.75" spacer lift, ARE topper, SP Performance Pads & Slotted Rotors, 4.10 gears
    Use your spray lubricant of choice and spray into the housing where the release fork meets the slave cylinder. There's a rubber boot there that you can pull off or back so you can spray inside. Try to spray to the center where you think the release fork to be.
     

Products Discussed in

To Top