231mm brake upgrade PROBLEM on 2001 Taco dbl cab

Ran into a problem upgrading my 2001 Toyota Tacoma dbl cab to the 231 mm Tundra Brakes. The Tacoma uses a banjo fitting, which as I read through the many write-ups didn't see any mention of. In fact one writeup on t4r.org showed the 231mm install with the banjo fitting.

In either case, I am kinda stuck on what to do and wanted to see what others have done. Don't want to have to put back together and double work, so without a vehicle till I figure this out.

This is the old caliper



This is the bolt for the banjo fitting;



This the the new caliper, which generally uses a hardline fitting;



Any suggestions?

 

from some of the write-ups i've read:


Modifications required:
-Bending the dust cover / disk shield.
-Drilling out the end of the banjo bolt approx 1/8”-1/4” deep.

 

This ^^.

Here are some links you might find helpful:
http://www.yotatech.com/f2/tundra-brake-upgrade-onto-tacoma-s13we-100145/
http://www.customtacos.com/forum/showthread.php?t=76847

At least a couple of them confirm Vin's response above.