Tacoma World Forums

Tacoma World Forums (http://www.tacomaworld.com/forum/)
-   1st Gen. Tacomas (http://www.tacomaworld.com/forum/1st-gen-tacomas/)
-   -   LCA w/ ball joint (http://www.tacomaworld.com/forum/1st-gen-tacomas/272442-lca-w-ball-joint.html)

Inverno4 04-09-2013 11:37 AM

LCA w/ ball joint
 
Is it possible to get new LCA w/ ball joint already installed from a reputable company? I know Moog seems to be a good aftermarket brand but was wondering if they even made these. It sounds like changing lower ball joints alone is a bear without the Incredible Hulk around.

mrbeggins 04-09-2013 12:12 PM

Changing lower BJ's is actually not that bad. At all. A lot easier than the uppers I'd say. Just rent a puller from your local auto parts store and change them yourself. Soak everything the night before in liquid wrench then have at er the next day. I bet you'll have it done by lunch time if you started in the morning. Both my sides took less than 2 hrs. Just my .02

Inverno4 04-09-2013 03:09 PM

Do I need a press to put the new ones in? I used a puller for the tie rods after mangling a pickle fork. What a pain in the ass.

StAndrew 04-09-2013 04:30 PM

Moog ball joints don't need a press, just paint:

Left and Right:
http://www.amazon.com/Moog-K90258-Fr...er+ball+joints

http://www.amazon.com/Moog-K90259-Fr...er+ball+joints

Get some zerk fittings too, they have the hole, just not fitting.


All times are GMT -7. The time now is 06:59 AM.