Reeeno403's Build "Brodozer"

how well can you see out of your back window with the rack and tent? or not at all haha.

 

Yup, Allpro LT kit with Walker Evans Suspension. In the rear I have an ATO shackle flip kit.

Well I can see out of the whole back window.....but I only see tent for the most part haha. I just use side mirrors and if it warrants I will stop and get out to see how much room till a tree or car or whatever is behind me. That doesn't happen often though. My rack was sized so I could still go in and out of my parkade. The truck really values +20 C* year round. Also regarding the look....I like the nice stream line look of the truck with out a big square wind block poking up.

 

DSC_2295.jpg by BurningChr0me, on Flickr

 

A few new pictures for the looking.

Burningchrome's tight 5th Gen about to roll some deep.



The wide girl hanging out with some friends in the forest


After climbing through the mini rock garden in some fresh stuff


Dat Ass


These lightforces are still for sale


Daisy Aspen Rosana


Might be the last time I save daisys ass


Poser shot


Daisy and Rosana


First Snow of the year


The rears are all trimmed and undercoated meow.


This is where Aspen Came from

 

I love your truck. I love the look of the 2+ LT kits without fiberglass it looks so beastly

 

What do you all use for undercoating up there? Looks like you have less rust under this thing than I do.

 

Truck is rolln beast mode Ryan! Lookn super dirty these days Makes me want +2 and DirtyFives soooo bad!

 

Haha I agree! The truck is definitely wide enough for my liking now. The factory fenders trimmed up give a nice look too! I need to get the flares back on asap.

I like to think I have no rust....but there is for sure a little surface rust going on. I should spend a day under the truck one weekend and clean it up. I have dealer installed undercoating. I also wash under the truck pretty good every time I clean it. Thats once a week if not once every two weeks.

Do it! 35's have been on the truck since I purchased it but dam happy to have the diff drop off and the LT working. Got in a little Baja love this weekend!

 

Did you get your front bumper powder coated or did you paint it yourself?

 

Its powder coated. Care of CBI! Its holding up really good too. No flaking, pitting, rust.....its all good!

 

Does your truck sit higher than Jamie's?

 

Yeah the coil overs are cranked a bit more than his setup he has on daisy.

 

Freeze put together a short video of the latest trip to Rubicon.
http://www.youtube.com/watch?v=ZimG11MX3Eg

 

When's your truck going to make it it the video, it needs a little more color in there

 

Haha lucky they were not wheeling in snow. We might have lost them.
I hope to do Moab in 2014. Just depends if I can get the lockers and gears done in time for a trip.

Theres a good shot or two of my truck in its old form back in 2011 in this Whipsaw video....you might have already seen this.

http://www.youtube.com/watch?v=dIOOHQN8glI

 

The sas'd first gen in that vieo is sooooo bloody clean it was almost mind blowing.

 

The Brodozer has come a long ways! And thanks for bringing back my nightmares of that trail.... especially seeing your truck go through the puddle and make it look easy.....

 

Broab

 

Changed out my A.D.D. Actuator last week. Happy to have 4wd back again. While I was under there I also noticed that my Driver side inner CV boot had a tiny hole in it so Jamie and I swapped that out on friday night. While the axle was out and the boot was off we had a chance to look for any wear marks on the axle shaft and it looks like there is signs already that the axle might be rubbing a little like Jamie had happen on Daisy.
Haha and this weekend myself and Littlebluetaco had someone recognize our trucks from instagram which was funny.

 

I think the problem with the allpro lt axles is only when you have walker Evans coilovers everyone with foxes don't seem to have this problem.