FS: Toytec 1" aluminum lift blocks

SOLD/CLOSE THREAD

 

Ill take them. How do you want the payment?

 

PM Sent. Thanks.

 

Buyer flaked, these are still available.

 

what do you need apart from that just the center pin and longer u bolts right?

 

they already have the center pin on them (you can see it on one...it's there on the other one too, but it's on the back side in the picture).

I don't even think you need longer u-bolts for the 1" block. The stock u-bolts are long enough, if I'm not mistaken...you just loosen them up, let the jack down slowly about an inch, slide these in and tighten 'em back down.

 

can anyone else confirm: stock u-bolts have enough room for 1" blocks? I don't want to tell you the wrong thing...

 

I didn't use the stock u bolts with my 1'' block, because I would have only grabbed a couple threads.

 

thanks rab...ok, so yes it looks like you'd need new u-bolts. You do not need any new centering pins or anything though. The bottom of your factory centering pin fits into the hole you see on one side of the block, and then the pin that you see on the other side of the block takes place of your factory pin...and fits down into the hole in the axle/bracket.

 

still available

 

Man would jump on these if had U-Bolts with them, Good Luck with sale. BUMP

 

fballer: they are sold pending payment to another member, but i will keep you posted if the sale falls though. thanks.