Parting out 2006 4cyl auto regular cab white

LOL!

Inverter in a Regular Cab?

We're lucky we have cranks that make the windows go up and down

Bumps!

 

I was thinking the exact same thing!!

 

Does your RC have a steering wheel?

 

Mossyoaks- The mirrors I have are unpainted and manual mirrors (non power)...is this what you need? In fact, what I have you can get on Rockauto.com for about $30 shipped, new. Shipping to your zip is going to cost me at least $15. I recommend the 'new' route.

Jrahn- the others are correct- This white truck does not have an inverter. I have an X runner I'm repairing, but will need that plug for when it's complete.

Blktaco- I have visors, but they're not cloth, they're vinyl, and at this second, not sure the condition. What material do you need?

 

I was looking for grey vinyl, I only need the driver side.

 

Blktaco-sorry cant find the drivers visor. Sorry.

 

Okay, let me know if you do find it.

 

bump

 

bump

 

I'm needing some flat plastic trim to do some fabrication with. Thinking either the bed cubby doors, or a large slice of the dash, maybe some interior trim (like a door or a knee panel). What do you still have that might fit this odd request?

 

Some of the back corner pieces of the regular cab interior have large-ish flat areas. Can you give me a little more detail on what a minimum size would be? I would need to cut these corner pieces to make them more practical for shipping. Also a zip code would help to calculate shipping.

 

Do you have the cover that I am assuming covers where the passenger's airbag shut off key switch is supposed to be? Or the power outlet cover. Not sure. It is a small triangle cover to the right of the clock/airbag info piece and directly below the passenger side left hand dash air vent. Thanks! Shipped to 40403.

 

This little guy!

 

Do you still have the wiring harness for the rear ABS?

 

I'm not really looking for anything particularly huge. The large (driver's side) bed cargo cubby door would be about the right size, maybe bigger. About the size of a large school textbook...?...
Ideally the pieces would be grey, but black is fine too.
Zip is 92653.
Thanks!

 

Jakers- I have the harness but I need to see how far it runs till a connector so I know how much effort I'm getting into.

Mach- yeah pretty sure these pieces will work. If you could PM me with an email, or phone number for a smart phone I can send pictures. And they are the standard interior grey.

 

Do you have the lower center console part that has the 2 cigarette lighter plugs? I would be interested in that piece if u still got it.

 

I would be interested in the whole cab/engine harness, as well as all of the running parts (airbox, ecu, and gauge cluster) with key and ignition.

I have a 2trfe sitting in my shed that i took out of my 2008, and now i have a serious itch to put it in my 79 yota for my next play truck, but i need all of the other stuff. (tranny is a r151 from turbo truck)

I may even be interested in the engine and accessories as well so i have more parts to play with.

Or maybe even the truck minus anything else you want to sell (like the bed, axel, wheels, tranny, door, exhaust, springs, glass)

I need to source all of the junk to make this engine run again, or if the price is right i could use yours and leave mine in the shed!

 

BUMP

 

do you still have the left front airbag sensor/ harness?