285-65-18's

question i just bought a 06 tacoma dc 4x2 the guy did a lift on it 5100's all the way around. the front is set at 0 with a 2 inch spacer very little to no rubbing i would like to remove the 2 inch spacer and run it at 1.75 setting do you guys think it is possible if i have to trim the fender liner that is not a problem any ideas will help.. here is the only pic i have so far

Thanks
Tacoma world

 

Think you need at least 3" lift to fit those tires. depending on type of tire and BS of wheel.

Post these questions in appropriate sections.

 

that spacer kind of defeats the purpose of the billies. Do that and then get an alignment of course.

 

I ran 285/65/18 with just a little 1 1/4 inch spacer us front with no rubbing issues at all?

 

Lift is not needed. Lift just determines when the tire is going to rub on up travel.