07 Reg Cab Seat Swap

I really need some help. I have managed to get hold on 2 bucket seats from an 06 Tacoma. Am not sure what model. But I have ran into a few probelms. The connector on the wiring harness for the passenger seat doesn't mate up and the seat belt buckles does not fit the latches. Any suggestions?

 

http://www.customtacos.com/tech/index.php?page=index_v1&c=6

Its on that page somewhere. good luck

 

any luck with this?

 

just wondering if you could take a pic of the connectors underneath the seat. I am going to try this swap. This is how I am going to try to address these issues.

1. Either: a)swith the male buckel to one from a double cab by removing the plastic peices that keep the buckle form falling and trying to replace it

b)get the whole seatbelt setup from a double or access cab from junk yard that I got the seats from

2. for the wiring i will see if there is a different connector that serves the same purpose and rewire for the new connector or just see if leaving it disconnected means that the airbag is constantly on and not just when a sufficient load is in the seat.

 

No, I have not had any luck with this. Other project have taken a priorty. If you figure something out, I would love to know. I have the seats but have not switched them out as yet.