I picked up the two position seat heater switch that was discussed here and am all set to wire it up, there were no instructions included with the switch, and the seller says it can not give technical support.
The switch has three lugs on the bottom, and a thin black wire. From my testing, the center would seem to be where power would come in, and one of the two outer lugs would be power to the seat heater. The resistance is lower on one lug then the other (hotter seat?).
If I wanted to have a hi/low setup, would I run both the outer lugs to the red (power) lead for the seat heaters? This seems like the correct way, but before I melt the heaters and set my seats on fire, I thought I would check to see if anyone here had done this.