1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

ARB high output on-board compressor, problems with pressure output

Discussion in '2nd Gen. Tacomas (2005-2015)' started by TacoNewb, Jan 16, 2011.

  1. Jan 16, 2011 at 7:41 PM
    #1
    TacoNewb

    TacoNewb [OP] New Member

    Joined:
    Jan 28, 2010
    Member:
    #30213
    Messages:
    4
    Gender:
    Male
    San Diego
    Vehicle:
    05 Prerunner SR5, 4 cyl, 2wd
    ARB rear locker, ARB onboard air compressor, ICON coil overs, Total Chaos UCAs, ICON rear shock struts w/ reservoir, Re-geared, added leaf pack, flowmaster exhaust.
    I'm currently running an ARB high output on-board compressor for by ARB locker in the rear. I ran into a problem trying to fill up my tires after sanding, it wasn't putting out enough air to fill up the tire and over stressing the compressor. Any suggestions to improve this on-board compressor system to inflate 285s. I want to install a tank to go with the ARB compressor, but is that even possible?
     

Products Discussed in

To Top