DT Short Tube Header Dyno sheets...anyone?

I just saw the GB thread tonight, and honestly, how can I pass that up

I 99% of the time, I'm below 3k rpm. Given that, I assume the short tubes are best (albeit at a more difficult install). Anyway, I looked at one of the long tube graphs, and it looks like they dont make power until I pass 3k rpm, right where I tend to shift .

Anyway, I guess this is the long way of asking if anyone has a short tube dyno graph or knows where I can find some to look at? I tried searching on here, but not finding what I want.
Help is of course, appreciated

 

Well, if for nothing else, I found a good post on how to make the weld and install less expensive

http://www.tacomaworld.com/forum/2n...-tube-vs-dt-shortie-headers-3.html#post806728