cool shift knobs

threaded insert plus some epoxy and boom you are done!

 

Which grip is this? I know dirt bike world but wondering what to type into Amazon

I am thinking aluminum bar stock?

 

I picked up this one at Autozone today. It's a little heavier and feels good in my hand. I wish the stem was a little shorter though, not sure how to do that.

 

Haven't been on here much. Traded the Taco in for a 16' 4Runner TE. Here's the schematics I drew up when I made it.

 

ok.. now your gonna have to explain some of that to me as the machine shop told me I was needing to go to school lol.... 64 mm x 8mm hole to a 20.75mm deep tapped m8x1.25 threaded hole. then from the other side a 30.5mmx18mm hole for the cap. All made out of 30.5mm aluminum stock thats 130mm long.

Is that right?


I figured it was pretty easy but I told the guy I wasnt the one who drew it up so I wasn't sure why it wasn't to scale. all measurements look right from what i figure.

 

You pretty much got it except I sourced an alu stock and cut it to 130mm and put it on the lathe to get it down to 22.15mm. The rest you got bang on. I don't do this for a living so that awesome drawing was just for my use. Lol at the machine shop guy comment. I'm far too lazy now to do a third University degree. Two is good enough for me.

All that said, PM me your address and I'll send you the one I made. I don't see myself using it in the 4Runner. If one day you end up not using it, then just pay it forward.