Toyota installing URD Throw-Out bearing repair kit under warranty...what clutch kit??

dropped my squeaking 08 Tacoma off at the dealership today. The Service Writer didn't even ask me why I was there. I asked about the URD TO Bearing Kit, he said they have done -4- already. I am at 59,555 miles, it will be isntalled/covered under the Powertrain Warranty.

If I provide a clutch kit, they will install that as well. I see URD has Stage II, III, IV.

I have a TRD S/C, TRD CAI, and Magnaflow muffler (turn-down). I haul a dual-axle trailer with a Mazda RX7 race car about once a month. Drive it likes it's stolen the rest of the time, trails, winter driving, etc.

What URD kit do people recommend? Thank you for your help!

 

They will install the URD TO bearing kit and a clutch kit under powertrain warranty????

 

since I have the dreaded squeak / chirp from the throwout bearing, clutch.

I will definitely take them up on that offer!

Just curious what clutch would be right choice? Stg III or Stg IV from URD. I'm leaning towards the Stg. III, would like stock feel, with more clamping power.

 

I have the same issue, how much you think it will cost ? im out of warranty

 

bump, hey OP hows it going? what clutch did you end up going with?

 

it rocks!

http://www.urdusa.com/More-Products...utch-Kit-for-1GR-FE-6-Speed/product_info.html

Regards,

PB

 

Hey OP,

I am really interested in trying out the URD TSK for my throwout bearing woes. Gonna go with a Stage II also. Was wondering if you could offer a little insight as to how this sleeve kit is holding up? Have you noticed any new noises or vibes? I think its about three months since your install... Any info, greatly appreciated.

Thanks!

 

holding up just fine. No issues, squeaks to report. Overall, very happy with this setup.

 

I know this is an older thread. Looks like it's been a few more months since your upgrade. Wondering if you've had any issues with the URD/PDM Throw Out Bearing Kit?

I have a 2007 4x4 6spd with 105k miles, and it's just now starting to squeak a little bit. Dealer estimated $1400 to repair it with stock parts.

I was looking online and found some other drivers with issues with the PDM kit, not sure of course if they installed the right part or if done properly. Thanks for any feedback on your truck's progress.