1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Soldering Flux Dechroming

Discussion in '2nd Gen. Tacomas (2005-2015)' started by deceitfulfate55, Jan 17, 2012.

  1. Jan 17, 2012 at 11:07 AM
    #1
    deceitfulfate55

    deceitfulfate55 [OP] Well-Known Member

    Joined:
    Jan 30, 2011
    Member:
    #50232
    Messages:
    118
    Gender:
    Male
    First Name:
    Tyler
    Hanover, Pennsylvania
    Vehicle:
    10 Tacoma TRD Off Road
    URD Short Shifter, Slim Cubby BiXenon and Fog HIDs, Bull Bar, Blackout Grill, Plasti-Dipped Front Valance and Badges, Diff Breather Relocation
    Just wondering if any of you guys have tried using zinc chloride soldering flux to dechrome anything. Building a satoshi and I'm at the point I'm going to attempt to dechrome it. Looked into it and there's a lot of ways that are supposed to do the trick. Easy off, pine sol, bleach, muratic acid (these solutions worry me).... just wondering if I'll probably end up trying it out and figure it out. Worst comes to worst ill freeze and try power washing it off which I know a couple other members had success with.
    Thanks in advance for your input

    Link about some dechroming methods
    http://www.garagejournal.com/forum/showthread.php?t=12840
     

Products Discussed in

To Top