1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Light Bar/bumper ideas need input

Discussion in '2nd Gen. Tacomas (2005-2015)' started by NelsonTacoma, Jul 3, 2012.

  1. Jul 3, 2012 at 8:40 PM
    #1
    NelsonTacoma

    NelsonTacoma [OP] This is my derpawayinator!!!!!

    Joined:
    Mar 25, 2010
    Member:
    #33969
    Messages:
    2,081
    Gender:
    Male
    Tucson, AZ
    Vehicle:
    06 PreRunner TRD Sport 03 4Runner Limited 4wd
    Bilstein 5100's , 6000k HID Hi/Low Kit, Magnaflow Muffler, 1.5 inch AP Wheel Spacers, Mudflap Delete
    So I'm thinking of fabricating my own front bumper/light bar. Has anyone else done this before? If so does anyone have some good design ideas or measurements/dimensions for mounting points?

    Not sure if I want it to replace the whole front bumper or just go over it like a light bar.

    Any thoughts or ideas would be appreciated. :)
     

Products Discussed in

To Top