Shackle Mounts to an ARB

A few questions:
I'm almost completely sold on getting an ARB for my 2012 Taco (assuming ARB ever gets around to producing them...). One of my main complaints is the lack of shackle points. I found some weld-on shackle mounts at Cut Throat 4x4 that I would like to mount to the ARB. Has anyone else done that before? What would the best place to weld on the shackle mounts? Should I powder coat them before or after being welded on?

Thanks!

 

I am considering buying a set of these. See what you think.

http://www.purefjcruiser.com/xd-shackle-mounts-with-backing-plates-pair-p-3937.html

 

I looked at those, wasn't sure they would be any better than welded on shackle points. I also like the idea of leaving the bump points on the ARB alone, if that's at all possible. I understand the best point to weld them to is as near to frame mounting points as possible with as much support to pull from.

 

People have been complaining about this for years. I wish they would do this from the factory but it'll probably never happen.