UCA rubbing coil after 3" lift

just put a 6 in spacer!!!!!!

lololol jk jk

 

Finally figured this out. When I went to install the Diff. drop spacers I realized there were some already installed. My truck has a lift already. I honestly couldn't tell. I had wondered a couple times and had looked at the front coils but there were no spacers. This was evidently lift springs. I'm guessing 2 inch. I did wondeer when I lifted the back and removed aluminum 1.5 inch blocks. I figured they were factory but was suprised they were not steel. I have always went with 6 inch lifts on all my other trucks. Feel kinda stupid that I didn't realize. I'm going to leave the 3 inch rear blocks for now. Tomorrow I'm taking the front spacers out and then I will try to figure out how much lift I have in front. I have 33x12.50x18 Toyo MT's on the way so I may add an inch spacer up front. I will need the 3 inches up front especially. Thanks for all the help!

 

What is your measurement centre of hub to fender up front now ?

 

I'll have to get that tomorrow. Do you mean currently, or after I pull the spacers?

 

Before and after

 

Before, 24.5" after 23.5". I also found a paper tag on one of the front springs. They are old man emu springs. Called and gave them the number and they were able to tell me that they are 2" springs.

 

Interesting

 

2 diff drops!

 

OP , are the coils 884 , 885 or 886's ?

 

They are 885's