Blown head gasket stuck the piston ring fast

I'm new here but i'm a Tacoma guy and what I've read so far is to good all ready picked up a lot of info so thanks so much.Had my 2005 blow head gasket the other day 107.000 miles and was looking at dash when it happend saw heat gauge going up pulled over before even went all the way up but to late pulled motor and one ring stuck,i heard if water level gets to low heat sensor is delayed.Any way what i'm looking for from u all Tacoma guys is some were I can get parts fast like rings bearing motor kit and so on,I don't want any racing parts just the same as or stock i'm having a hard time finding them and i'm sure some of have been there and done that,any help would be great thanks in advance and great job in the forums.Oh the other night the one on the wedge in the top of the door got my locked keys out thanks.

 

Someone here should know.

 

id look for a used motor myself

 

please use correct puntuation.

Have you checked junk yards?

 

if english and grammer are importent too you you should joyn a prissy english fourm an get over it their an keep it away from here an thats fo real dude

 

Holy run-on sentence batman!

I would definitely look for a used motor. By the time you tear it down and machine both the heads and the block (which will most likely require pulling the motor to do correctly anyway, you're gonna be somewhere close to the same cost. Once that kind of damage is done, the motor will NEVER be the same...I went through this will my last truck. Should have just picked up a used engine, dropped it in and been done. Just my $.02...

Good luck

 

I was just saying that he (OP) was hard to understand. I didn't mean anything rude by it.

Now, to you on the other hand...

grammar**

important**

to**

join**

forum**

there**

and**

that's**

for**

 

OP, look into a used motor. There are plenty out there. I use Car-Parts.com for junkyard parts.

 

If wanting parts I'd check with gadget at URD he might have an idea of where you could obtain said parts. And then maybe xrunderground.


also
http://www.lceperformance.com/SearchResults.asp?Search=1gr&Search.x=12&Search.y=14

 

Well thanks u all that was great! Sorry for not replying. I've
Been busy.No just wish I could have had the time to chat some
On these forms,as soon as I have some time I'll go thru and
See what I can learn from u all and thanks for the these tacoma
Guys got it going on I need all the help I can get.Any got motor
Back together in truck and runing like new again.I put stock
size rings,bearing kit,gasket kit,honed cyclinders and cleaned
Up all others parts with a wire wheel and adjusted vavles and took
4 days full days labor as for never done before. Was planing on
Just pulling heads but down loaded schematic and it read for bad
Head gaskets 1 remove battery 2 remove engine assembly started to
Look at motor and the front piece goes top to bottom and bends to the
Back of the motor,u can't adjust vavles pull heads or do much
Without pulling but in the end all was good I just wish I could of got u alls
Tips before hand could have saved time oh it took almost as much
Effort to get parts quick and the weight ones thanks again.

 

Yeah no problem man. I'm glad you have fixed the issue. I would have just got a new motor, I am not that technical. Plus 1 for you sir

 

x2

ItS ThE InTeRnEtz

wHo karez?

 

I DO.
I really do not think it is that hard to write complete sentences followed up by a period.