1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Toytec carrier bearing drop (longterm effect)

Discussion in '2nd Gen. Tacomas (2005-2015)' started by TAC1, Oct 31, 2012.

  1. Oct 31, 2012 at 12:29 PM
    #1
    TAC1

    TAC1 [OP] Well-Known Member

    Joined:
    May 13, 2011
    Member:
    #56594
    Messages:
    2,843
    Gender:
    Male
    First Name:
    Tac1
    Miami, FL
    Vehicle:
    2015 DCSB O/R 4WD
    Hello Forum,

    I have a question regarding the cb drop spacer kit. I understand it's purpose is to get the 2 piece drive shaft angle as close to factory as possible for a 1 to 2 inch lift. What about the angle of the driveshaft entering the tranny? doesn't that get thrown off from lowering the cb? Can that damage anything?

    Thanks:D
     
  2. Oct 31, 2012 at 12:39 PM
    #2
    TherealScuba

    TherealScuba Sober Member

    Joined:
    Mar 28, 2012
    Member:
    #75781
    Messages:
    1,153
    Gender:
    Male
    First Name:
    Stephen
    Austin, Texas
    Vehicle:
    99 Single Cab 4x4
    It's such a minimal degree change at the transmission that, as far as I know, the drop doesn't hurt anything.
     
  3. Oct 31, 2012 at 12:44 PM
    #3
    TAC1

    TAC1 [OP] Well-Known Member

    Joined:
    May 13, 2011
    Member:
    #56594
    Messages:
    2,843
    Gender:
    Male
    First Name:
    Tac1
    Miami, FL
    Vehicle:
    2015 DCSB O/R 4WD
    Sounds good to me. Thanks
     

Products Discussed in

To Top