Mike "Wuzzy121". Rest in peace, brother

Go Back   Tacoma World Forums > Tacoma Discussion > 2nd Gen. Tacomas

Notices

Aux Fuse Box Panel Needs Advice...

Reply
 
Thread Tools Search this Thread
Old 12-30-2012, 01:26 PM   #1
Denk [OP] Denk is online now
Senior Member
Denk is on a distinguished road
 
Denk's Avatar
Name: Nick
Joined: Oct 2012, #88739
Location: Washington State
Gender: Male
Posts: 123
Denk's Tacoma Gallery
Aux Fuse Box Panel Needs Advice...

I've completed cutting/bending the panel and fabbing the main support, however, the back edge is still a bit flimsy. Do you think it would be a good idea to use the lower bolt on the master cylinder?

Panel - 22ga steel sheet (probably should've gone 16ga on this, oh well...)
Main Support - 1/8" steel rod

Here's a wide shot showing the bolt I'd like to use...



This is the main support, utilizing a bolt in the main fuse box mount...



General shot of the panel. I still need to cut out the red circles for routing wires... or do you think I'd be better off cutting slots or smaller holes to maintain integrity?



Thanks for the help. This place is invaluable!
  Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
Aux Fuse Panel In Cab? Forster46 2nd Gen. Tacomas 35 06-21-2012 08:56 PM
WTB: AUX FUSE BOX Forster46 Buy / Sell / Trade - Other 3 01-03-2012 06:12 PM
What do you have on your aux. fuse box? 2000GTacoma Lighting 10 11-28-2011 07:38 PM
ok finally started on my aux fuse box myth01 2nd Gen. Tacomas 0 02-17-2011 05:06 PM
Questions about aux fuse panel install Tim A Technical Chat 3 04-12-2010 06:13 PM


Copyright © 2014 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.