I was searching the forums this morning looking for a way to get rid of that annoying seatbelt chime when I have 'heavy' items sitting on the passenger seat, and for that annoying beep when unlocking and locking the doors with the key fob. I came across these 2 links:
Step one: Open the drivers door and insert the key into the ignition
step two: Remove the key from the ignition and, within 5 seconds,
reinsert the key back into the ignition and switch to the on position.
Step three: After 10 seconds, the system enters the answer-back mode
step four: Within 10 of the answer-back beep the switching mode is
started, press the remote twice and teh system will turn off
or on based upon which the system is set.
1) Turn the Car 'ON', but do not start the engine (Leave your foot off the brake). Cycle your trip reset knob until it reads ODO. Turn the ignition back off. Wait a couple of seconds.
2) Make sure seat belt is not fastened
3) Turn the ignition back on, do not start the car (Leave you foot off the break) As soon as you see everything light up, press and hold the trip reset knob and do a long 12 second count.
4) Keep your finger on the trip reset knob. Fasten your seat belt, as soon as you fasten your seat belt, you should see the ODO display go from XXXX miles to "b-on". At that time take your finger off the trip reset knob and press it again. It should cycle to "b-off". You should be all set and turn the ignition off and unfasten your seat belt.