P275/65/18 DynaPros on stock (non-lifted) Taco

Folks,

I've decided on wrapping my BFD's with Hankooks DynaPros (P series) and wanted to see if anyone ran 275/65/18s on a stock set up. I know a couple of folks did on Duratracs and had to trim. Has anyone ran the dynapros specifically? I would like to avoid lifting if at all possible. Thanks in advance

Edwin

 

Same problem over here! I wanna see pictures.

 

Not sure if it helps but here it is on KPT's truck but in 265/65/18s with very similar wheel specs

http://www.tacomaworld.com/forum/2nd-gen-builds/87828-kpts-super-white-build.html

Edwin

 

Blackyy,

I think I found it... not exactly on DynaPros but I believe he's stock height

http://www.tacomaworld.com/forum/2nd-gen-tacomas/220737-dark-horse.html

Edwin

 

Well I took the plunge and purchased the 275/65's and am glad I did. Here it is on my '13 taco with no lift. Other than about trimming 1.5" from the rear of the front fender and removing the little black lip on the front (two 10mm bolts), the tires clear just fine on these wheels. No issues clearing the UCAs













Edwin

 

Very nice and great pictures by the way.

 

I have 275/55 20 Hankook Dynapro ATm's. About the same tire hight and width as you're wanting. No lift. Just a little trimming.