HELP! 4x4 vacuum line??

First post...

I bought my '06 Tacoma 6spd about 3 weeks ago knowing it needed clutch work.

I started tearing into it this past weekend. While doing the job, I "accidentally" unplugged a vacuum line. It was the last thing I had to remove before the trans was ready to drop, so i gave it a little tug to see where it went and it popped right off of wherever it was attached! Problem solved, right? Wrong.

Now I am in the process of getting this beast back together and I cannot for the life of me figure out where this vacuum line gets reattached.

Take a look at the low-quality iphone pics below and let me know where this thing goes!! All help is appreciated.

Thanks guys!






sorry for the bad lighting, pretty sure it goes somewhere around here...

 

looks like thats the breather on the end. basically it goes as high up as u can get it. im sure there is an attachment point somewhere up there to hold it but it doesnt connect to a line somehwere else

 

Yep, that's the trans breather. I think there is a clip on the back of the engine. It will be really close to the firewall if it's the same as the auto.

 

Thanks guys! Quick response too!

I was going crazy looking for where it went. I found the clip attached to the top left bellhousing bolt. I assumed that was for electrical.

 

If it's not too late, get an upgraded throwout bearing while you are at it!

http://urdusa.com/Clutch-and-Flywhe...IT,-2005+-Tacoma-V6-6-Speed/product_info.html

 

Trust me, i did my research. Already installed!

A bit pricey, but i hear its worth it.