When replacing my gauge face, I thought I set the needle back to the correct position, but apparently not. Now. When filling up, it wont read past between 1/4 and 1/2 tank of gas. It tries.. but then clicks back down.. Like its stuck.
I think its reading its "full" and wont go any higher, meaning I need to reset it so that "highest" point is actually at the full mark instead of where it currently sits.
Only way I can think of fixing it and knowing where my fuel level is, is to fill the tank to full... (until the pump shuts off) then turn the truck on, let it reset the needle, and then set the needle to the full mark. Ill just have to watch it for the duration of the tank, see how many miles I get, then when it hits the low fuel light, fill it up again and see how many gallons it takes.