Blacking out my Taco, suggestions on crome bumper?

I'm blacking it out, getting rid of all crome. Looking for suggestions on the rear bumper.

 

Sand it with 80 grit, apply etching primer, and Plastidip that thang.

 

You mineswell spray paint and clear coat the bumper if you are going to go through the trouble of sanding and using self-etching primer for plasti-dip

 

I went with the body armor. It looks great and sets it off a bit more than the stock bumper in my opinion.

 

Dip it .

 

Definitely try the dip to see if you like the way it looks. No need to sand.

 

^^^THIS^^^
(My rigs doppelganger)

 

yep i cleaned mine, and dipped it, 2 winters later i just hose it off and its clean as a whistle.. and hasnt peeled anywhere

 

After sanding the shit out of the chrome I gave the bumper a couple coats of bed liner. Tough stuff and I haven't had any chips in the almost 3 years its been like that. Looks pretty good too! I used the same bed liner on my light bar in the front so it matches back to front.