2013 tacoma wiring harness behind blanks

So, i know this is a bad picture but it serves the purpose.



Im wanting to install led lighting in the bed of my truck. I want to use the blank on the left of the a-trac spot in my middle console (left side of steering wheel is full). When i pulled the blanks, the far left had a white wiring harness, and the right had a black. Could someone explain what these are for? I figure id bypass them to do my own wiring unless there was a way to put them to use.

DAC, rear diff, fog lights, curtain bag shut off, etc... Is on my left side of steering wheel.

Thanks in advanced.

 

bump. I have the same thing but on both sides almost like it was for wiring the factory seat heaters... I wonder how far the wiring goes...

 

How did you pop those out? I been trying to figure out how without damaging the plastic around them.

 

I am in the middle of installing a Pioneer radio so with the radio and ca controls removed, I just reached my flings down there and pushed. Popped right out. I needed to get the factory aux/USB out to wire it up to the pioneer.

 

Sub'd

 

They pry out ... time and patience ... and a small plastic screwdriver.

 

This is what I am in the middle of looking at right now...
It is for seat heaters, I have the switches installed, but trying to find out where the other end is at for the heater elements.

http://www.tacomaworld.com/forum/2nd-gen-tacomas/354630-need-help-factory-pre-wired-seat-heaters-part-numbers-factory-switches.html