Has anyone installed these on their 2014 Taco?

KASEI LIGHTS TY311OE-2

What do U think? I'm all prewired:}

Let me know, Thanks....


http://www.amazon.com/Toyota-Driving-Replacement-Harness-TY311OE-2/dp/B00JFD7DVM/ref=sr_1_1?ie=UTF8&qid=1402698093&sr=8-1&keywords=KASEI+LIGHTS+TY311OE-2

 

Since my truck came with items like this my answer would be NO.

 

Groovy, thanks, still hoping to get some feedback:} PLEASE

 

I recently bought a 2014 , 5spd, standard cab Tacoma. Mine , like yours has no fog lights and I would like to install a set. You said you were all prewired. I have some questions concerning the wiring. Do you have to run the entire harness all the way back or is there a Molex connector inside the engine bay that you can connect to. I understand that the switch will have to be wired back to the cab.

Also, how do the plastic inserts that are in place of the fog lights come out? I would assume that they simply have plastic clips that pop out.

 

How D

From what I discovered, my truck has the plug/wires to the cab
Also wires to the place where the fog lights are to be installed.

So, I was told/read somewhere that I simply need lights, a rely and a switch.

However; I can never get a good answers on what fits and what doesn't, I have read and many folks to me seem vague or I can't understand what they mean. Probably my fault since I cant's talk wiring lol

So....I haven't done squat simply because I'm to ignorant lol

Good luck, if you figure something out PLEASE let me know, I'll do the same.

 

I have the factory fogs and I am switching to this..... Factory fogs suck
http://www.tacomaworld.com/forum/li...es-sr-m-fog-light-conversion-2012-tacoma.html

 

There is a thread one here that lists the part numbers. I did mine right after I bought my 13. Relay was $10 on eBay. I bought the switch from Camelback Toyota. They are one of the vendors on here. It was around $45. The fog lights were another $45 on eBay. I got a corolla kit, they are the same lights. About half the cost of the tacoma sets. You just use the lights don't need the rest of the kit if pre wired.
It all took about 45 minutes to install.
Just two screws holding the plastic covers in place. The same screws you mount the lights with.

 

Wow Thanks

Been looking for the thread that has the part numbers....I want to run yellow

If anyone knows the numbers or can lead me to the thread, I'd certainly appreciate it.

Again thanks

 

the factory 2012+ fogs are actually quite nice IMO, sharp cut off wide beam that emits good light close to the vehicle.

 

This thread has the part numbers and some other info.
http://www.tacomaworld.com/forum/2nd-gen-tacomas/204749-2012-fog-lights-solution.html