33"s ??

i bought a set of 33x12.5 for my Taco but they still rub against a back wall, it already has a 3 inch oem bolt on lift kit. I was wondering if a leveling kit would still work on top of the 3inch lift...?

 

Can't recommend stacking lifts. Is it rubbing on the cab mount?

 

Are you 4x4? If so, it will create binding for you CV's as well as leave you with little to no down down-travel creating a very harsh ride.

If you are a prerunner, you won't have to worry about binding CV's since you have none. But, you will still severely limit your down-tavel by reaching the limit of your upper and lower control arm travel, which isn't a good thing.

If you do have a 3" lift, you should be able to fit 33's with minimal trimming. I'm willing to bet if you get the cab mount chop done, you will have little to know rubbing left.
http://www.tacomaworld.com/forum/ba...n/192527-b-m-f-cmc-plates-cab-mount-chop.html

 

Yea
Its has a procomp lift like this were they just make the struts 3 inches longer

 

Oh ok, would i have to do cut some of the flares too, because they rub there too

 

I did have to at the bottom on the inside of the wheel well.

 

Ok i probably end up doing that wall chop. Didn't really think of that ha, thanks for the tip.