1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Wheel well trimming with aftermarket bumper?

Discussion in '2nd Gen. Tacomas (2005-2015)' started by Sparky2012, Jan 24, 2015.

  1. Jan 24, 2015 at 9:02 PM
    #1
    Sparky2012

    Sparky2012 [OP] Well-Known Member

    Joined:
    Oct 22, 2011
    Member:
    #65672
    Messages:
    46
    Gender:
    Male
    Oregon
    Vehicle:
    Tacoma Double Cab 4x4
    Leer 100 RCC canopy, Relentless aluminum front bumper, car seats of my twin minions.
    I know that there are a lot of after market bumper installs on the board so your opinions would be appreciated. I just installed my Relentless aluminum front bumper and I'm not sure how I want to trim the inner wheel well skirt. I've just got it zip tied in place for now. How have you guys done it to make it look clean and secure? Should I just cut it flush and add a skirt piece to fill in the gap between the skirt and bumper?

    Thanks.
    And I'll do a review on the bumper when I get it all finished.
     
    Last edited: Jan 24, 2015
  2. Jan 24, 2015 at 9:27 PM
    #2
    Sparky2012

    Sparky2012 [OP] Well-Known Member

    Joined:
    Oct 22, 2011
    Member:
    #65672
    Messages:
    46
    Gender:
    Male
    Oregon
    Vehicle:
    Tacoma Double Cab 4x4
    Leer 100 RCC canopy, Relentless aluminum front bumper, car seats of my twin minions.
    Never mind. I just found a tread about this in the armor section.
     

Products Discussed in

To Top