LED LIGHT BAR WIRING HELP!!!!

I've searched and searched and searched some more. I found one good thread rhoppas. I followed it to an exact T i grounded out my switch than tapped into the Guage fuse for the switch. I ran a wire from my relay to my switch, a wire from the battery to an inline fuse, from the inline fuse to the relay and from the relay to my 50" LED light bar. I have tested the wires and from the battery to the fuse and fuse to the relay I've got power. and from the switch to the fuse box I have power but nothing in between if that makes sense? Can anybody please help?? I know its an ongoing topic but I just can't find anything

 

first of all did the light bar not come with a wiring harness?

do you have four wires connected to the relay? should be two power, one to the switch, and one to the lightbar.

 

can you post the diagram

 

like this???? link: http://static.summitracing.com/global/images/instructions/smt-76246_led light bar wiring.pdf

 

Yes, post a diagram, it will help us more.

You should have this,

Switch:
Pin 1: Ground
Pin 2: Ignition On (Gauge fuse)
Pin 3: To pin #86 on relay

Relay:
Pin 30: Inline fuse then battery
Pin 85: Ground
Pin 86: To Switch (above)
Pin 87: Positive wire of led bar

Led bar:
Positive wire: to pin 87 of relay
Negative wire: ground

Edit: Post #4 will work as well

 

there is a misconnection somewhere-Fuse?

 

the link has good instructions and possible remedies.

 

Diagram has the relay enable contacts opposite from this post.

 

Yeap, cause pin 85 and 86 are the coil. One will hook up to 12v and one to ground

 

Yes=not sure it makes a difference here -some applications it might.

 

He must have FIXED IT!!!

 

Sorry guys I've been workin on it. I can't figure it out! The switch diagram and relay diagram are contradicting each other. Lemme try and draw up a diagram I'll get after it tomorrow thank you I appreciate it!

 

What kind of switch is it?

 

Otrattw, I think that's what's so confusing is the switch diagram contradicts the diagram I was following I'll post more info tomorrow and hopefully someone can help me figure out what the problem is! Thanks guys

 

Note* Any electrical work should be done with extreme caution

Are you sure your relay is pinned the same or the internals? It may be a normal on relay and when you apply power it is switching off. Best get a multi-meter and read the power out pin with everything hooked up. Break down the connections and find where your vDC is stopping. Happy hunting.

 

What model rocker? I too have a otrattw switch

 

It's the duel light top red bottom blue. It has 5 prongs on the back. I'll post a diagram this afternoon once o get off work and have time to work on it again

 

Alright. Sounds like you have the same one I have

 

I'm tryin to post photos but it's givin me hell and won't let me. Let me try again

 

^^upload the pics to photobucket or something similar then link them