What was your FIRST mod?

my first mod was the day i bought her!!! I took the mud flaps off then lifted her and put wheels an tires on and a indash

 

removed dealer plate/sticker the day I got it home, then weathertech floor mats

 

Window Tint / Clearbra

 

removed the mud flaps...

 

removed secondary air filter

 

i voted exhaust but my very first mod was removing a red sticker on the back that said "Toyota of Des Moines" that was gone the second i drove it into the garage

 

I trimmed the retarded long front mudflaps.

 

1) Removed mud flaps (after one pulled off the first time off roading).
2) Rear Differential Breather (and spare tire mod) after first time in deep water contaminated the differential oil. Flipped the spare over so you can access the air fill valve on it, without dropping the tire.
3) Replaced Rugged Fails with Hankook Dynapro ATMs 265/75-16
4) Light bar (custom made) from my '05 added and modified for 4 lights (2 Euro HIDs, 2 Halogen 100 watt Pencils)

 

Putting a step bar on today and throwing on a rubber bed mat so I can put my dog in the back.

 

Removed mudflaps and de-badged.

 

Lift, Tires/wheels, BHLM.

 

Engine break in mod: I drove it like i stole it all the way home

 

window tint

 

First was the KN CAI, then came the westin bull bar, then poweraid TB spacer, then came the window tint, next was the lift, then put rain vents and stone deflector, then the DIY washable cabin filter, then the squeaky leaf fix, now I got a set of JBA headers to install will prob do that on the 18th. After that could be one of a few things. Either cat abck exhaust, sliders, or the old fashioned roll bar/light bar for the bed will most likely make a junkyard pull with that.

 

My first mod wasn't until last weekend. Using an add-a-circuit I wired a 3 outlet 12v accessory port to an empty fuse slot that turns on with my ignition and mounted it inside of my glove box.

Then I installed my satellite radio in the cubby under the radio and drilled a hole to run the wires to it directly behind it. Ran the power cord to the accessory port in the glove box. All the wires for it are completely hidden now.

In the 2nd power port I plugged in the GPS and ran the wire up inside the dash over by passenger side column and then ran it along the bottom of the windshield to the middle of my dash so now all you can see of that cord is what is about 8-10" of it.

Now no more wires going up the middle of my dash.

 

bought a tonneau cover and bitch bars

 

TRD Skid Plate; TRD Wheel locks; Toyota Bed mat and Toyota Hood Protector installed on purchase of truck. So if you count those as mods, so be it.

If not, I've ordered Smitybilt Step bars in powder coated black. Should be here in a day or 2. That will be my first aftermarket modification.

 

I added locks to the bed storage compartments.

 

First off got bigger tires, then took the secondary air filter out, and just today for a whopping $23.54 I put blue LED lights on the floor boards

 

X2!! Also installed AMP and 12" Kenwood Sub behind back seat! What a bitch that was!