Delta00's 2002 Tacoma 4WD

Go Back   Tacoma World Forums > Tacoma Discussion > 2nd Gen. Tacomas


Removing/disconnecting the middle seat belt in a regular cab 2009

Thread Tools Search this Thread
Old 08-23-2009, 11:20 PM   #1
kauaijim [OP] kauaijim is offline
Junior Member
kauaijim is on a distinguished road
Joined: Aug 2009, #21047
Location: Kapaa, Hawaii
Gender: Male
Posts: 1
kauaijim's Tacoma Gallery
Removing/disconnecting the middle seat belt in a regular cab 2009

Does anyone know how to remove the seat belt or at least disconnect it at the connection piece down at the seat area? Do you drill out the plastic welds and pop off the cover? I'll never use it and I'd like to get it out of the way to install a set of wet okole seat covers. Unbolting it from the floor looks as if some wiring to the belts will be disrupted so I'd rather do it at the other connector.
  Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
disconnecting middle seatbelt on bench seat JBeasty 2nd Gen. Tacomas 21 10-22-2013 10:54 AM
For Sale: Wet Okole Seat Covers for Regular Cab Bench Seat Kelson 2nd Gen Tacoma Marketplace 33 07-23-2011 10:58 PM
For Trade: 2009 Taco SR5 4.0 6 speed Access Cab for Regular Cab xxaarraa Buy / Sell / Trade 8 09-15-2010 07:21 PM
Removing door panel 09 regular cab manual windows RTTacoma 2nd Gen. Tacomas 2 07-09-2009 06:24 AM
removing pillar cover(the one that houses the seat belt) tacomaman06 1st Gen. Tacomas 6 07-24-2008 08:55 PM

Copyright © 2015 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.