What Have You Done To Your 2nd Gen Tacoma Today?

Thanks!

OME 885x with OME front and rear shocks(no top plate spacer, wanted to stay at 2.5" of lift to retain stock UCA's). 3 leaf progressive add-a-leaf in the back. Sitting 3 inches higher now but should settle down a bit.

 

Replaced the headlights with the redesigned oem ones. The old ones were horribly glazed and the dtrl lenses were both melted and cracked.

 

Are those the factory "smoked" Sport headlights? They look good

 

Yes they sure are. Thanks

 

Very nice!

 

I bought some fj steelies off eBay awhile back. I had a misunderstanding of the backspacing; and found that my 285s only cleared the UCAs by about a 1/4".

So now I have 5 of them taking space in the garage.

 

[QUOTE="OldManTan";8506447]That's a long shot with our salt, no? Or what are you doing to prevent rust would be a better question? I would love to see 2 or 3 and would be happy, but I think it will be rotted out by then.[/QUOTE] For under $40 (3 cans) and starting with the boxed sections of the frame first then work outward, Fluid Film
seems to be the SHIT!

 

The beauty of craigslist I got the hook up on a truck cap/camper shell/topper what ever you call them in your area. It is silver streak mica, but doesn't actually look bad on the Spruce Mica. I might not worry about painting it since it adds some contrast. $375...I'll take it.

 

Where'd you pick those up at?

 

Finally painted my sport rims! The bright stock silver was too much with a black truck. Painted with Duplicolor graphite metallic wheel paint & clear. I still have the pieces taped off and plastic over the brake calipers and discs in this pic. Planning to do the logos in the same colour so I'll have to remove from the truck. I tried plastidip but didn't like the finish up close...

 

Finaly got my Rigid Industries grill and LED bar installed and hooked to an OEM style switch.

 

Where do you get that switch I need one for my fogs and future off road lights and want to use the factory panel like you did

 

Installed a G4 Fold-a-Cover.

 

I got it from a company on eBay called air on board. They have all kinds of different push switches for what ever your wanting it to control. When installing make sure you read and re read the wiring diagram because I had some issues with it. Basically the only color that matched the others was the ground.

 

Thanks and I have no wiring going from scratch so should not have a issue there

 

I made a sleeping platform for $35 and a couple of hours.

 

Installed new shoes. Fierce Attitude M/T 285/70/17. Washed and waxed. There should be 5 in the stack. Installer started before I could snap the pic. Wanted 35"s but PCSing to Germany so i think that would be a bit much for the parking garage's over there.

 

bought her a new tag:/ and replacing the windshield:'(

 

Did my 30K service. First time I've done any of this on my truck since Toyota took care of it for the first 25k.
Oil Change....switched to Mobil 1 full synthetic 5-30. Also put in a Fumoto drain valve to make future oil changes easier because of my Pelfreybily IFS skid.
Oil Filter-OEM
Air Filter-OEM
Diff oil change. Used Lucas 80-90 dyno oil
Changed out spark plugs.

 

What should I google to find those?