What Have You Done To Your 2nd Gen Tacoma Today?

What was the part number for the Denso spark plugs? I'm at 60k and need to change mine. I don't think they've ever been changed.

 

Battery Hold-down by Coupe.... nice work....

 

X2. You need a MUCH beefier floor jack to lift the truck safely. I got a 3-ton low-profile jack in the garage that lifts 4"-21", so I can use it on both my Subaru and my Taco without wooden blocks. The thing weighs 101 lb though, more than a Hi-Lift, so it makes no sense to bring it on the trail.

 

Just get them through the dealership. They're pretty cheap. Like $25 for all 6

That is one clean engine!

 

K20HRU11 for standard (30k change interval)

$53 SK20HR11 ---- IRIDIUM PLATINUM power pack Spark Plugs -- # 3421 ----- 6 PCS NEW

SK20HR11 for iridium (100k change interval) - about twice as expensive as standard plugs if you get them through Rock Auto. The dealer parts counter will rape you.

 

flat black on black

 

Tried out my 6 ft 220 lb frame in the access cab rear seat today. It was not as uncomfortable as I feared.

 

I washed, buffed out my trail pinstripes, cleaner waxed then polished it just in time for it to rain.

 

Pahala...take an exacto blade with a fresh tip and you can pierce those air bubbles in your decal and press it with your finger to get rid of most of those

 

Just dropped my baby off to have my new grill insert installed! Cannot WAIT. Pics to come

 

when u add on the base plate and adapter -that is an expensive setup for a bottle jack...

 

I believe I have the 48" lift. I'm going to keep it. I just purchased the SOS sliders with bolt-on steps. I'll have to go back and check but my hope is that I can use the Lift with the sliders. If not, there are other uses, as has been mentioned.

 

Something to always remember: when fixing to drain the fluid from ANY transmission, transfer case, diff ALWAYS, I repeat, ALWAYS make sure the FILL plug/bolt will come out BEFORE you drain the case.

 

Added a new member to the Toyota family last weekend. My wife just had to have it, guess i cant complain its a nice rig!

 

^NICE! Sweet color. Needs more black, just sayin

 

Installed a 2013 taco radio in my 2012 base AC.

 

tested out my hi lift jack base today, using 3/4 inch plywood it doesnt even budge, bow under the weight of the truck!! i put my base up on 2x4's just so i knew the entire load of the vehicle was pressing down on the wood base, so if it were to snap it would have done so in a safe manor

held up great and was free!! now time to paint the 2 pieces of wood black and seal the hell out of them with outdoor polyurethane and be done with it

 

Wrapped my door handles with paracord

 

Looking forward to seeing that!

 

If they are made from 3m 1089 film they will go away on their own.