What Have You Done To Your 2nd Gen Tacoma Today?

Added EGR inchannel vent visors today.

 

Gave it a good hot bath

 

through the wheel well? that must've been hard.
kinda sucks having to take the skid plate off, but it's worth it having that 'protection'.

 

X2...Plus Waxed it with Meguirs NXT (new Wax) Very Nice, even my wife noticed a difference

 

I took mine dirt biking. Before that, I debadged it. Maybe I'll paint 'em black or not.

 

I failed to remove the steering rack bushings...

 

Installed an OEM hitch purchased from TW member Oswego. Hooked up a Hoppy T connecter for the lights (wish I would of bought a Curt connecter instead, made in the USA vs the Hoppy which is hecho en Mexico) and finished off with a Curt 4 pole to 7 and 4 pole adapter installed in the OEM location to look as factory as possible.



Scheduled for the spring TSB on Thursday.

 

installed Nfab bar and bed lined my grill

 

cut a small hole in my airbox last night. might enlarge it and just do deckplate mod.

 

Took off 2nd air filter from my airbox. Found out that there is no good location on the 2nd Gen airbox to do deckplate mod

 

installed the ultra gauge... now to see how much of a lead foot i have

 

I picked mine up from the dealership!!!!

(err... will be picking it up in two hours)

 

Serviced the rear DIff this morning. The tranny, front diff and transfer case are next weekend.

 

Gave her to the dealer for TSB work, service tranny, wheel bearing, diff leak, and to check the whine turbo sound while hitting the gas

 

im replacing my lower radiator hose soon as the radiator gets thru draining. had a damned pin hole in it and leaked all my coolant onto my garage floor. glad i looked under there....was actually looking at my suspension. hell...i replaced the hose less than 10k ago when i did my water pump and timing belt.

 

I just did this...

http://www.tacomaworld.com/forum/2nd-gen-tacomas/116697-headlight-replacement-southpaw.html

 

Pick up the truck from the service dept. and tomorrow I'm getting a new starter at 30,000 miles and TSB work done also (tranny mount) T-SB-0132_08

 

cleaned some of the inside.

 

Drove it to school.

 

replaced the shifter lever seat(58$) and shift lever bushing cap(8$). now the shifter isnt shaking all over the place and it seems to go into gear much easier.