What Have You Done To Your 2nd Gen Tacoma Today?

Wishing I got this one instead of the Adavanced that I have now.

 

I finally rinsed it of for about the second time since I got it. It was only incidental to me needing to pressure wash the gunk off an old hilift that I got, so the truck shouldnt feel too special.

I'm missing the mud already...... I bet it is sitting in the bay all sad and lonely wishing to have the wind flowing by and meeting it's relatives all over the area.......

 

Nice...but now there's one more damned tonneau to think about!

Actually..not really...just visited two sites and neither list it as available for the Tacoma.

 

Upgraded to all JL components while retaining a 'factory look'
Before, sound was really poor - now it rocks!

M.

 

Really? I'm sure it sounds great and is a vast improvement because I love JL Audio but I would say you did anything but retain the factory look.

 

This.... Why not just put them behind the panels?

 

X2

It is easy to do and add some sound insulation for a really decent sound.

 

I like the idea of the speakers not being blocked by door panels or other obstructions. I suppose I could take a look at putting them behind the door covers ... thanks
As far as 'factory look' - sitting in the drivers seat - not much looks different than before... the two little knobs (clean sweep volume and bass control) are really the only thing that changed on the dash and front doors. Rear seats remain fully functional.
I seem to have lost a foot rest on left side of the clutch pedal, but that's shouldn't be too problematic, all else remains

 

Looks good, but I'd be concerned about your foot rest. It'll take time to get used to it, and how many times will you kick it before that happens?

I had ones in my corolla in a similar location and I was always kicking the grills off on accident. And you don't have grills to protect the cones.

 

I hate these rims, but yours look great. I might just do this to mine now. Great idea.

 

I'd end up with mud in my speakers

 

Whole new meaning to muddy sounding speakers...

 

I put my CleenSweep knob a little closer so it was more within reach.

 

What is a clean sweep knob?


Over the past month I have been working on my truck.

Got a Revteck 3"/2" leveling kit
XD Addict Rims
295/70/17 Nitto Terra Grappler

Also going to install 48 white LED dome lights toinght and 1" Wheel spacers as soon as I get them in!

 

Always wondered about this one. Are the kick panel speakers typically "marine grade" to withstand water and dirt?

 

Practiced for moab.



Me and a locked up 87

 

have to redo my center console fabric :/ apparently the contact cement wasn't good enough (dunno), but will be adding in some 3M 90 to it (seems when it's fairly warm or just gets hot in the truck, the cement is VERY goo like and the fabric can be peeled off in a sense). Although somehow the front pillars seems to be holding out fine.

 

Here is a link to clean sweep: http://www.jlaudio.com/cl441dsp-car-audio-oem-integration-98110

My understanding is that it removes all the filters and restrictors found in OEM audio systems that are designed to "play safe" rather than damage speakers.
The clean sweep also distinguishes highs, lows and mids according to where they should go rather than bunched up all together into any speaker

 

ordered some audio stuff finally.

 

The Cleensweep is for the JL line converter so you can have amps on the factory head.