Pulling fogs out

How would i go about pulling the fogs out of the oem bumper?

 

They should pop out, want to sell them to me?

 

Anyone around fullerton,ca have yellow spray tint?? i dont think autozone carries it and super autobacs is a drive to garden grove that i dont want to make

 

use a flathead screwdriver, be careful and they just pop out.

 

I just pulled mine out today. This was the easiest way for me.

1. I removed the two screws at the front end of the fender. This allowed me to move the liner out of the way.

2. Remove the light bulb from the fog light housing. Careful not to touch the bulb.

3. Move the wiring harness out of the way.

4. Back the adjustment screw out from the light housing. It's located at the bottom of the light housing.

5. I used two small flat head screw drivers and I wedged them between the tabs on the lights and the bumper. A slight bump and they popped right out. Getting the tabs to give was the hard part.

6. Install was just the opposite but alot easier.

Hope this helps.